Pressure Switch CW211300AV
Part Number: CW211300AV
Order within the next 13 hours
and your part ships today!
and your part ships today!
*This part replaces obsolete part #: CW211300AJ.
Product Information
Description:
This genuine manufacturer-sourced part is specially designed for use with Campbell Hausfeld and Ridgid air compressors. The purpose of a pressure switch is to control when the compressor should start and stop building up pressure. There are several reasons it could be leaking air, unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Note, this pressure switch cuts in at 120psi and cuts out at 150psi. Keep in mind this high-quality part is sold individually, Please refer to the appropriate diagrams of your model for the correct location and application of this pressure switch. |
Compatibility
This part is compatible with the following machines:
the 11 compatible machines
Products Compatibility
This item works with the following types of products:
- • Compressor
Questions & Answers for Pressure Switch
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
2 of 2 people found this instruction helpful
Tool Type:
Compressor
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Wrench Set, plumbers tape
Regulator stopped working
Very easy.
Remove old parts.
Wrap threads with tape.
Install new parts.
Set regulator for desired cutoff psi. (they put wax over screw, remove wax and fill tank to desired psi and turn screw to the left until you hear "click". Regulator psi now set.)
Remove old parts.
Wrap threads with tape.
Install new parts.
Set regulator for desired cutoff psi. (they put wax over screw, remove wax and fill tank to desired psi and turn screw to the left until you hear "click". Regulator psi now set.)
Did you find this story helpful?
Thanks for voting and helping fellow customers!
1 of 1 people found this instruction helpful
Tool Type:
Compressor
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver
Compressor would not stop adding air reaching a point of popping pressure valve
Removed the parts that did not come with the new pressure switch. Open the cover, made a wiring diagram, and disconnected the wires, then removed the old switch. Installed the new switch. Connected the wires. Put on all of the parts that were removed from the old switch.
The compressor work like new again
The compressor work like new again
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Compressor
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Socket set, Wrench Set, Adjustable Wrench
Pressure switch stuck
Replaced switch
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Reviews
2 Reviews
Average Rating (out of 5):
Click to filter by ratings:
5 stars
2
4 stars
0
3 stars
0
2 stars
0
1 stars
0
< PREV
- 1
Fit just fine
The part was great Just what we needed.
Timothy -
September 27, 2023
Verified Purchase
Honest, it works better than new
The pressure switch arrived but internally was different but all the piping was correct. After installation I crossed my fingers it was correct. It pumped up to 160 pounds and shut off. I was never able to control the output on the secondary now it' perfect.
Guest -
November 5, 2020
Verified Purchase
Verified Purchase
eReplacementParts Team
< PREV
- 1
Product Information