The pump builds pressure but when I hit the spray it is like water hose pressure. Does my pump need rebuilt?

I get no pressure and the motor bogs down with water in the oil. I can not find a leak.

The engine works great but I do not get any pressure from the wand. The water comes out of the wand just like from a hose.
What do you think is wrong with the pump?

How do I know if my pc2525sp is a type 0 or 1?

The oil plug on the side of the pump leaks after the machine has been in use for 5 minutes, blowing out oil. Is this just a plug change?

I was using my power washer and it was successfully dispensing soap. I turned the machine off for about 45 minutes, and rolled it to a different location by my house. After that, no soap wo;uld dispense with the low pressure nozzle or any nozzle. I do not understand this. The chemical hose is not clogged. I ran a thin wire into the nipple that dispenses soap, it did not appear clogged. Please advise. Thanks.

Can I change my cold water pump on a porter cable power washer to a accept hot water?

any help would be appreciative;i've been thru the carb twice,replaced the needle & seat,checked float needle pop-off pressure-o.k.,disconnected the on/off electrical switch & the oil low level device still the engine dies when you load it;the engine will idle fine or even run on high speed but as soon as you pull the trigger on the wand,the engine dies but you can start the engine right back up on one pull;i think the pressure relief circuit is not working & i am loading the engine too much & stalling the engine;i have been at this for several days;pleae any help

I forgot to blow out the water in the unit before winter. Now the copper body part has a slit in it that water is spraying out of. What is the name of this part? If I order it can I replace it myself.

Thanks,