Repair Parts Home Power Tool Parts Milwaukee Parts Milwaukee Band Saw Parts
Milwaukee 6230 (SER 678J) 4-3/4 Inch Deep Cut Band Saw Parts
How to Change a Bandsaw Blade
Changing a bandsaw blade only takes minutes with the help of this article's professional power tool tips, including proper bandsaw blade guide adjustment.
Bandsaw Tire Replacement
This article gives step-by-step instructions to loosen new bandsaw tires for easier installation.
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Milwaukee 6230 (SER 678J) 4-3/4 Inch Deep Cut Band Saw
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Milwakee 678d Smoke Coming From...
I have a band saw that when i pull the trigger smoke comes from the cord where it connects to the handle. I thought it was the cord so I replaced it with another, It didnt work at all. I put the old cord back in and now it doesnt work at all any ideas?
Reply: Milwakee 678d Smoke Coming From...
If you have a volt/ohm meter you can check the cord for live voltage to make sure it is OK..I assume that when you re-installed the old cord you shortened it below the bad spot an then reconnected :)
There is a chance the switch is bad also but try to eliminate the cord first as a problem and then troubleshoot the rest of the tool..switch,brush's and so on..
[I also assume that the cord you replaced it with was a new one?;)
A test meter can be purchased at any hardware store or radio shack..
Hope this is helpful..
Accessories for the 6230