Repair Parts Home Power Tool Parts Makita Parts Makita Hammer Drill Parts
Makita HP1621F Hammer Drill Parts
How to Remove a Stuck Drill Chuck
Broken gearboxes and sticky chuck screws can make removing a drill chuck difficult. This article explains the tricks you need to overcome these common repair setbacks.
Drilling, Fastening, and Hammering Power Tools
This article lists the major categories of drilling, fastening, and hammering tools, and explains the basic applications, types, and features of each.
How to Remove a Drill Chuck
This article explains steps for how to remove threaded-on chucks and taper-fit drill chucks, as well as steps for removing a spindle from an open-center chuck.
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Makita HP1621F Hammer Drill
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Brush Replacement
I bought this Hammer Drill about four years ago for medium to light use. Mainly to drill 1/4 inch holes in granite counter tops to anchor wine racks and such. I used it about eight times and it all of the sudden quit working on me! At the time i was under a deadline so i just threw it in the back of my car and used a co workers for a while. I thought it might be the VSR switch. Upon further investigation i found that the Makita factory had not properly snapped the right side brush all the way into the holder.
I am not sure if this is a once in a blue moon incident or if this happens often on this model. But i definitely recommend checking the brush holders first and foremost if your drill happens to stop working! Other than that issue it has been operating properly, and as long as you don't hammer on it to hard it is a very good drill!
Question: Drill Chuck Removal
any body know how to remove the chuck on a makita hp1621 hammerdrill?
Reply: Drill Chuck Removal
[QUOTE=stunami;7404]any body know how to remove the chuck on a makita hp1621 hammerdrill?"
You might try opening the chuck all the way look in side there is a screw that connects the chuck to
Review: Makita - HP1621F
I usually have little problems with Makita power tools, however Makita's keyless chuck on the hp1612f is a piece of junk!
Reply: Makita - HP1621F
I Agree it is junk it is a shame because the drill it self is very good.It needs a keyed chuck.
Reply: Makita - HP1621F
I agree about the keyless Chuck being a piece of junk. I took back the first drill because the spade bit could not be removed. The Keyless chuck fell completely apart on the replacement drill. This ruins an otherwise good product.
I did contact Makita about this problem and they completely ignored my problem. I doubt I will ever buy another Makita product. Both drills were brand new when they malfunctioned.
Accessories for the HP1621F