Guide Bushing Adapter 329120-01
Part Number: 329120-01
Order within the next 13 hours
and your part ships today!
and your part ships today!
Product Information
Description:
This authentic item is supplied directly from the original equipment manufacturer for use with DeWALT routers. It is an identical replacement for a missing or a damaged guide bushing adapter that was installed on a new unit. Please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually. A screwdriver will be needed to perform this repair. |
Frequently Purchased With
Compatibility
This part is compatible with the following machines:
Products Compatibility
This item works with the following types of products:
- • Router
Questions & Answers for Guide Bushing Adapter
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
1 of 1 people found this instruction helpful
Tool Type:
Router
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver, none
No repair
The item purchase was a perfect fit. However, it required two small #4 metric screws that not only did NOT come with the bushing, but was also very difficult to locate in our small town. After three days of looking, I finally found what I needed. It would have been really nice if the bushing had come with the mounting screws. I did go back and looked at the parts diagram and did see them next to the Adaptor. They are part number 911141-00.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Router
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver, Thread locking sealant
Needed an extra pilot bushing adapter
I had problems with a router bit pilot bushing staying tight in the adapter plate, so I ordered an extra adapter plate to dedicate to this particular bushing that is used for a mortise and tenon jig. I used Loctite "red" thread locker on the bushing to keep it secure in the adapter plate. Now I can easily switch out the adapter plate to use the jig without worrying about the pilot bushing falling out.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Router
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver
missing and old used/broken parts
I put parts in place and screwed in with the missing screws
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Router
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
just screwed part in and it works
nothing to tell,,, worked just fine
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Router
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Screwdriver
These are plastic parts that break every now then or get lost in warwick zone of the job site.
All of the parts just pop right into place. Except the Guide bushing adapter it uses two screws to hold it in.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information