Gasket 7313285849

1. Unplugged machine & made sure there was no water left in the basket
2. Unscrewed and then removed the metal filter from the leaking gasket
3. Used screwdriver to "wedge" out the old gasket
4. Put in new gasket and screwed the metal filter back in place

The hardest part was reaching three screws which secure the top of the machine. It requires a star drive. All of the other screws are small Phillips heads. After you remove those and two on the back, the top will lift right off.

I promise, everything is very intuitive. Unplug the hoses by simply pulling on them, remove the pump by wiggling it off its rubber mounts and unscrew the water valve connected to the pump the pump. Replace those with the new ones and reverse the process.

I chose to change a few of the other little pieces of tubing, simply because I was under the covers - super simple and cheap.

I also replaced the spring and valve on the head (where the water comes out) to ensure that the new pump didn't overwhelm an old valve.

This pump works perfectly in our Delonghi EC702, it actually is an improvement over the original one. With these parts changed, we have a completely new machine!

Thanks eReplacement for the super fast service and clear parts catalog!

Remove the diffuser, then what is left of the gasket.
Place the new gasket in and the diffuser.

1. remove the base
2. disconnect the water hoses
3. disconnect the electrical wires
4. remove coffee steaming components
5. replace coffee grinds holder gasket
6. put everything back together using pictures to make sure placement was correct on wiring.

1. Unscrewed the center screw.
2. Removed the metal strainer and them removed the gasket in pieces with the spatula.
3. Saved little spring loaded valve until my gasket arrived.
4. Then put the rubber gasket in place and screwed in the valve with the threaded plastic part.
5. Finally attached the metal strainer with the screw.