Fuel Filter A369000480

Primer Pump:
NOTE - Empty fuel tank before starting any work. Next, be sure to clean area around the Primer Pump before you remove it to avoid dirt/debris from getting in the pump.
1. Remove fuel tank guard/shield with a 3 mm Allen wrench.
2. Remove screws holding the fuel tank to the motor with a Phillips screwdriver. DO NOT remove the fuel line from the tank. Just move the tank out of the way to have access to the Primer Pump bracket.
3. Remove the Primer Pump bracket with a very small Phillips screwdriver.
4. Install the new Primer Pump.
5. Installed fuel tank.
6. Installed fuel tank guard/shield.

Air Filter:
1. No tools required. Air filter cover knob can be removed by hand.

Fuel Filter:
1. Remove the fuel filler cap.
2. Use a stiff gauge wire, or something you can "hook" the fuel line with, to pull it out of the fuel tank.
3. Carefully pull the old fuel filter off by hand then install the new fuel filter.
4. Install fuel line and filter back into the fuel tank.

Fill fuel tank with fresh fuel/oil mixture.
Prime pump and start.
Check for fuel leaks around Primer Pump.

Installed the carb repair kit, new tank grommet, new fuel filter, and tank vent. Had to adjust the high and low adjustments a bit, but now it starts and runs like a new one!

1. Removed "foot" from the base of the motor.
2. Removed pull starter.
3. Removed fuel tank, all tubes, and grommet.
4. Replaced grommet, tubes, and filters.
5. Also replaced air filter and spark plug.
No more leaks and unit runs well!

1. Removed gas tank
2. Replaced parts
3. Cleaned the outter components
4. Put it back together
5. Works like new!!

Remove the fuel cap and reach in with a long pair of forceps and get a hold of the fuel line and pull it and the fuel filter out. Remove the old filter and connect the new filter, Then put it back in the tank and replace the fuel cap
Remove the primer bulb cover and remove the old bulb and install the new one, then screw the cover back on.
Remove the air filter cover and remove the old filter and install the new one, then replace the cover.

Used a pair of forceps to removed the old fuel filter then connected the new filter and placed it back into the tank

replaced fuel filter, fuel line, fuel tank grommets, fuel tank vent and clip. Time required was to fix two machines. Very simple repair if you follow the directions

1. Replaced the carburetor and installed the new gasket between the carburetor and the engine. (needed 2 gaskets so used the old gasket between the carburetor and the choke input.)
2. Replaced the gas filter.
3. Replaced the throttle cable.

Replaced all parts from the gas tank to the carb

I replaced air and fuel filters and new spark plug. Once I completed repair saw would start but acted like it would run out of fuel. I let sit for 24 hours and then tried it and it has been running good ever since. I believe the new fuel filter takes time to become fully operational.