Float Bowl Gasket 81-2630

took carb. off put new carb bowl gasket in and a new gas line.

Replaced float bowl gasket

Put new seat kit and bowl gasket.

Removed the screw at the bottom of the bowl. Removed the bowl and spray cleaned the inside and the flow unit with carburetor cleaner. Re-assembled the bowl with new gaskets. Started the machine to make sure no leaks.

The first step was to watch some of your excellent "how to" videos. I then took off the cowling to remove the Primer Button on the dash. Then removed the carburetor, disassembled it and sprayed it with carburetor cleaner and used the thin gauge wire to run through all the orifices, and re-sprayed it again. I had to review the videos again because I forgot how to reassemble the needle valve into the float. Let me reiterate how excellent your videos are. I then trimmed the primer and gas line hose ends (they were cracked where the clamps are or in the pressed on areas). After reassembling the carburetor, linkage and hoses, and installing a new spark plug, I replaced the cowling, added the fuel mixture, primed once, full choked and cranked it. It started on the first pull. The blower is over 25 years old and works like new. Thanks for all the help I got from the videos and your quick response to the parts I ordered. Best regards, WES

Replaced all of the gaskets on the carburator to fix the leak around the bowl and as a routine maintenance because of the age of the snowblower.

Remove the float bowl with a 9/16 socket. Clean the bowl with carb spray install rubber gasket on bottom of carb replace the drain screw gasket and the bowl screw gasket. reinstall on carb and tighten the screw. Add gas and check for leaks.