Repair Parts Home Power Tool Parts DeWALT Parts DeWALT Electric Drill Parts
DeWALT DWD110 3/8 Drill Parts
How to Remove a Stuck Drill Chuck
Broken gearboxes and sticky chuck screws can make removing a drill chuck difficult. This article explains the tricks you need to overcome these common repair setbacks.
How to Remove an Armature Bearing with a Vise
This article explains one backup method for removing armature bearings when a bearing puller isn't available.
Drilling, Fastening, and Hammering Power Tools
This article lists the major categories of drilling, fastening, and hammering tools, and explains the basic applications, types, and features of each.
Electric Power Tool Parts 101
This article defines the basic parts of most power tools, explains how they work, and what to look for when they stop working.
Time Spent Repairing:
Entry Date:2013-12-13 10:05:24
0 of 0 customers found these instructions helpful
By overusing the drill working with a big concrete bit, the gear broke..
1)- disconnect the drill., 2)-use a Phillips screwdriver to open the drill,once you open it note how the armature assembly is installed, you can put it back in the same way it was., 3)-pull out the armature, carefully use the vise clamp to hold it and with the hammer to knock it and take out the ball bearing then the gear but make sure not to knock the pin too hard because it can get damage., 4)-put back the new gear then the ball bearing, if necessary put some grease by the gear and bearing., 5)- close it back, test it and that\'s it....
Discussion for the DeWALT DWD110 3/8 Drill
Accessories for the DWD110