Discussion for the DeWALT DW9096 Type 1 18V 2.4Ah Battery Pack
Post a Comment
Ask a question, answer a question, or post a comment!
where can I find the connector for the top of the dewalt 18 v batteries, not the whole top cover just the metal parts that make connection in the drill and the charger? The piece that sits on top of the single cell that sits on top of all the others?
Also I know what the thermistor is but what is the wire that goes from the center connector to the side of on of the cell, what is it for?
Question: Latch Compatabillity
Will the Latch Button (389657-00) work on the XRP batteries?
Reply: Latch Compatabillity
The latch buttons should work just fine with your older batteries. The latches are part #389657-00 and are available from http://www.ereplacementparts.com.
Good luck with your repair!
Question: Dewalt 18.8 XR NiCd Battery Rep...
Could you give me the repair part number for the Dewalt XR NiCd battery? The part looks like 8 C-cell batteries in connected in series to a male adapter that goes up to the portion that would plug into the tool/charger.
Reply: Dewalt 18.8 XR NiCd Battery Rep...
The internal cells of the battery are not offered for sale by the manufacture. The replacement for your DW9096 battery is part #389795-23 and is available from http://ereplacementparts.com.
Reply: Battery Charging
Over time batteries lose the capacity to take a charge. Internally your battery is made up of a series of C-cell batteries. As each cell goes bad the run time and performance of the battery pack is reduced. This is what may people perceive as a batteries "memory". After enough of the cells go bad the lack of run time and the reduced performance make the battery worthless. At that point it is time to replace it.
We do have new batteries available. The part number for your 18 Volt DeWalt battery is #389795-23.
Assuming that your charger is operating properly I think that your battery is worn out.
I hope this helps!