Repair Parts Home Power Tool Parts DeWALT Parts DeWALT Table Saw Parts
DeWALT DW745 Type 1 Table Saw Parts
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Remove an Armature Bearing with a Vise
This article explains one backup method for removing armature bearings when a bearing puller isn't available.
Electric Power Tool Parts 101
This article defines the basic parts of most power tools, explains how they work, and what to look for when they stop working.
Diagnosing Electric Power Tools 101
This article is a troubleshooting guide for problems and malfunctions common to most electric power tools.
Discussion for the DeWALT DW745 Type 1 Table Saw
Post a Comment
Ask a question, answer a question, or post a comment!
Question: How To Replace A Brush Holder On...
the brush holder is cracked it nees replaced how do you replace
Reply: How To Replace A Brush Holder On...
Sometime there are set screws in the housing on the motor which hold the the brush holder in. look for them hopefully they,ll be there.
Maybe there is some one else out there that can help us a bit better.
Question: Problems Locating DW745 Replacem...
I have ordered the part from ereplacement parts and it is the wrong one. The model number of the saw is correct however the part is not the same as the one on my table saw. I NEED HELP.:confused:
Reply: Problems Locating DW745 Replacem...
u need to be more specific,no way to help unless you give more info relating to the part you need.
ia the part number -5140032-55? then thats the handle
Question: Dewalt745 Table Saw, Replacing ...
Hi guys. Does anyone know how to pull out the power cables from the switch box? I need to replace the box and having difficulties pulling the wires out. Do those grommets holding the cables in place come somehow apart? Thank you..
Reply: Dewalt745 Table Saw, Replacing ...
if you still need info about those pesky grommets..
You actually have to squeeze the the head of the grommet[with a pair of needle nose pliers or a special tool made just for those] and pull out the grommet with the cord or switch wires..sometimes you have to get behind the other end and squeeze and push...:)
hope this helps..?
Accessories for the DW745