Repair Parts Home Power Tool Parts DeWALT Parts DeWALT Generator Parts
DeWALT DG6000 Type 1 Generator Parts
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Winterize Power Tools and Machines
This article explains how to properly winterize power tools and machines for winter storage, increasing the life and performance of seasonal tools.
Generator Maintenance and Use
This article offers information about generators, their proper use, maintenance, safety, and parts replacement.
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the DeWALT DG6000 Type 1 Generator
Post a Comment
Ask a question, answer a question, or post a comment!
I have a dg6000, when its running it puts out 124/241 volts. When I give it a load, the engine won't ramp up to handle the current draw. I don't know what to look for. I recently installed a new stator, due to the old one shorting out.
It looks like the auto throttle is controlled by a vacuum system. I would look there first. My guess is that the vacuum hose, item #580 on page D of the parts diagram, is either disconnected or has been damaged. If the vacuum hose is OK you will need to work your way through the vacuum assembly and inspect each part. The parts I would suspect are the check valve, item #564, and the diaphragm, part #560.
The vacuum hose is part #285804-16, the check valve is part #285804-01 and the diaphragm is part #285803-97. All of these parts are available from http://www.ereplacementparts.com.
I hope this helps with your repair!