Repair Parts Home Power Tool Parts Delta Parts Delta Jointer Parts
Delta 37-220 Type 1 6" Jointer Parts
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Discussion for the Delta 37-220 Type 1 6" Jointer
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Open End Cutter Wrench
My wrench came up missing and now I can't change cutters..is there a substitute for the original.
Reply: Open End Cutter Wrench
Even when that wrench was available the price was quite a bit for a stamped steel wrench. I have been telling woodworkers that you can purchase a good quality 5/16 wrench. Although you will have to grind it down to fit between the screw and the cutterhead. It should work for you for years to come.
Hope this helps,
Question: Rockwell/Delta 6" Jointer
I have a Rockwell/Delta 6" Jointer (Model 37-220) and it is missing the in-feed table height locking knob (Item 51 in the parts drawing schematic). It is no longer available to purchase through ereplacement or ace tools repair. Any ideas where I could search for a used one or where I could get a part spec sheet for the knob so I could have a machinist make one?
Reply: Rockwell/Delta 6" Jointer
im pretty sure i have one i have most of a 37-220 parts
Review: Delta - 37-220
This was a good little machine. Mine was made by Rockwell in Canada. Only problem I ever had was the fence was slightly twisted. It was impossible to have the fence square on both the infeed and outfeed table. I bought the jointer used and I can't image how the previous owner cut anything straight with it. My solution was to rig a steel flat to it to act as a lever. Then I took it outside to a storm sewer grate, stuck it in and twisted. Guess what? Cast iron will bend! A little bit of force was all it took. I also have an older Powermatic 8" jointer that does the bulk of my work, but this one is small, lightweight and portable. I really lament the loss of machines like this. I'm not so sure the new stuff is any better, but once the parts run out for my older equipment I might not have a choice anymore. For now I would say if you find a used Rockwell or Delta six incher, then buy it!
Reply: Delta - 37-220
i have a bunch of parts to help restore a 37-220