Curved Shaft Assembly 000998229

Air pump on Husquavarna:
1. Remove side cover and fuel lines from air pump.
2. With screwdriver, push in tab on rear of pump to release from frame.
3. Align new pump in frame and snap into place.
4. Use needle nose pliers to carefully attach fuel lines.
5. Press air pump bulb 3 or 4 times to check for leaks.
6. Reinstall side cover.

Drive shaft on Homelite:
1. Remove trimmer head assembly on end of shaft.
2. Remove safety guard from end of shaft.
3. Remove handle from shaft.
4. Remove throttle assembly from shaft noting how the linkage fits back in casing.
5. Remove clamp noting location.
6. Remove shaft assembly from engine.
7. Install new shaft and tighten clamp in same location as removed. You may need to turn end of the shaft so the new drive shaft slides into engine.
8. Install throttle assembly assuring throttle linkage works as you assemble.
9. Replace handle and safety guard on shaft.
10. Replace trimmer head.

1. Removed the string assembly and the cover for the shaft.
2. Removed the shaft from the engine.
3. Replaced the new shaft and clamped to the engine assembly.
4. Installed the cover to the shaft and the string assembly.

Disassemble shift from motor. Assemble head to new shaft. Assemble new shaft to motor.