Product Information
Description:
This part is an OEM from Makita. The compression spring 16 is compatible with several belt sanders. The metal spring is fitted inside the frame, providing the necessary resistance for related roller components. This item is sold individually, and a screwdriver is needed for the installation. |
Frequently Purchased With
Products Compatibility
This item works with the following types of products:
- • Sander
Questions & Answers for Compression Spring 16
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Sander
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
, None
Screw was bent.
1. Removed old parts.
2. Replaced with the new parts.
2. Replaced with the new parts.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Sander
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Wrench Set
Sanding belt would not track properly
I removed the screws from the motor housing, and removed it. I then removed the retaining ring holding the shaft and front roller in the roller arm. I then removed the old tension roller arm and placed the new one with the old roller shaft cup washers and retaining ring. I placed the complete assembly in the sander housing, then installed the cup washer, roller and shoulder bolt. I then replaced the motor housing, then replaced the compression spring, flat washer and adjusting screw. The sander now tracks better then before
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information