Carburetor Assembly (wa-5b) 12300003931
Part Number: 12300003931
Order within the next 12 hours
and your part ships today!
and your part ships today!
*This part replaces obsolete part #: 12200004130, 12200002830 and 12200000831.
Product Information
Description:
| This part is available individually. The carburetor is made out of metal. A screwdriver and a nutdriver might be helpful during the installation of this item. It will need to be replaced if it becomes broken. This is a genuine Echo part sourced directly from the manufacturer for use in saws. |
Compatibility
This part is compatible with the following machines:
the 18 compatible machines
Products Compatibility
This item works with the following types of products:
- • Chain Saw
- • Saw
Questions & Answers for Carburetor Assembly (wa-5b)
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Chain Saw
Repair Difficulty:
Medium
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Nutdriver
Carb needed replacement.
Echo cs302s chainsaw carb replacement!
1. Removed side cover with recoil starter.
2. Unscrewed clip holding fuel line in place.
3. Removed fuel line from carb.
4. Removed carburetor hold down bolts.
5. Removed cover over choke plate, then removed choke plate from rod.
6. Removed rubber plug (from right side of saw) for carb adjustment screws.
7. Disconnected throttle rod from carb and carefully removed carb from saw. (Make sure not to lose washers located between top of carb and cover over choke plate! )
8. Remove gasket from bottom of old carb.
9. Install is reverse of removal!
1. Removed side cover with recoil starter.
2. Unscrewed clip holding fuel line in place.
3. Removed fuel line from carb.
4. Removed carburetor hold down bolts.
5. Removed cover over choke plate, then removed choke plate from rod.
6. Removed rubber plug (from right side of saw) for carb adjustment screws.
7. Disconnected throttle rod from carb and carefully removed carb from saw. (Make sure not to lose washers located between top of carb and cover over choke plate! )
8. Remove gasket from bottom of old carb.
9. Install is reverse of removal!
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
