Repair Parts Home    Power Tool Parts    Ryobi Parts    827811 Brush and Spring (Sold Individually)

Brush and Spring (Sold Individually)

Part Number: 827811
Availability: Discontinued

This part is no longer available from the manufacturer.
Genuine Ryobi replacement part.
rnIncludes 1 Carbon Brush with wire lead, braket and brush spring attached.rn

• Worn brushes frequently are the cause behind a motor running poorly.
• Replacing brushes can fix a motor that’s operating intermittently.
• New brushes can restore a motor’s electric braking.

Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Discussion for Brush and Spring (Sold Individually) - ( 827811 )
You need to be signed in to participate in the discussion.
You need to be signed in to particupate in the discussion.
Ask a question, answer a question, or post a comment!
  • Subject:
  • Comment:
Question: Replacement Brushes


827811 - is there a replacement for this? Shame to have to trash this for lack of a part.
Reply: Replacement Brushes


Hello 1532814,

I did some research on the Ryobi 827811 827811 Brush. And there was some one that used the Delta part number 1313113 Brush. And they said it worked just fine

Question: Brushes


brushes and cap no longer available...what do you do when the brushes wear out... throw the tool away??? I need a set of brushes and one cap, please.
Reply: Brushes


Hello 1031724,

The Brush part number, 827811 is still available. As for the 827810 Brush Cap, which is no longer available. You should be able to locate a suitable substitute at a local power tool service center. Take the good cap to them and see if the can match it up.

Product Information
Manufacturer: Ryobi, Ridgid
Category Number: 827811
Classification: Part
Weight: 0.01 lbs.
Shipping: Ships Worldwide world wide shipping icon
Repair Guides
How to Replace the Blades on a Hand-Held Planer
For a planer to do its job, you need to make sure the blades are as sharp as can be. This article will walk you through ...
September 28, 2011
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool...
October 19, 2011