*This part replaces obsolete part #: 899568.
Product Information
Description:
This item has been sourced from the original manufacturer to be used with drywall sanders from Porter Cable. The brush is used to relay electricity from the switch assembly to the electric motor. Brushes make contact with the rotating armature and will eventually wear down and need to be replaced. This brush is priced as a single item, please note two brushes may be required. |
Compatibility
This part is compatible with the following machines:
Products Compatibility
This item works with the following types of products:
- • Sander
Questions & Answers for Brush And Spring (230 Volt Onl
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Sander
Repair Difficulty:
Easy
Time Spent Repairing:
15-30 minutes
Tools Used:
Screwdriver, Power Drill
Brushes were worn out and vacuum hose busted
Remove hose clamps by lightly prying with screwdriver
Replace hose and reuse clamps
Remove housing screws
Remove two screws that hold brushes
Remove one screw that holds brush and replace brush put screw back in then two that hold the brush housing
Repeat for other brush
Put screws back in housing
Done
Replace hose and reuse clamps
Remove housing screws
Remove two screws that hold brushes
Remove one screw that holds brush and replace brush put screw back in then two that hold the brush housing
Repeat for other brush
Put screws back in housing
Done
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information