Bolt V203000591

1. Remove Fuel tank Assembly (remove straps and hose)
2. Remove Carburetor from cylinder (remove screws and gaskets, clean with Carburetor cleaner)
3. Disassemble and Remove the Cylinder from the Crankcase (remove screws and gaskets)
4. Remove Muffler from the Cylinder (remove cover plate and screws)
5. Remove Piston from Crankcase (remove lock pins and bearing)
6. Remove Ignition Coil from Flywheel
Note: With the exception of the Ignition Coil and Muffler, I use carburetor cleaner to clean the cylinder and carburetor (internal/external)
7.Reverse the steps to reassemble- replacing the parts that are unserviceable with the new part(s).
Note: The gap between the ignition coil to the Flywheel is approx. one business card apart.

Just make sure that all of your new parts are laid out separately, in order to allow you to keep everything separate from the old parts that you will be removing. Take your time, clean areas and parts that you will be keeping as you go. Once all parts have been removed and parts cleaned, work your way backwards from the way you removed parts when installing the new parts. I use 90 degree type Allen Head wrenches without handles that way I do not over tighten fasteners. I had gasket material that stuck on me around the intake portal to the piston that needed to be scrapped off, so I brought the piston to TDC and stuffed a small bit of rag in the hole to keep debris from getting inside the head.
I also bought from a local store a replacement muffler and muffler bolts and gasket that was installed during this time as well, but the store did not have the other parts I was needing.
EVERY part that I ordered from eReplacement Parts fit exactly as the old parts, I did not have to make any adjustments to the new parts to get them to fit.
When I was finished, I primed the carburetor, adjusted the choke and slid the on/off button to on, and pulled the cord one time and it fired right up. I adjusted the choke and set it down and let it idle as I put my tools up and cleaned up the area I was working in.
I am very happy with my whole experience dealing with eReplacement Parts. I will be ordering again from them.