How to Test a Small Engine for Spark
If your small engine isn't starting, you'll need to diagnose many issues including the spark plug. This video walks you through the steps of how to test for a spark using a spark tester.
Quick Fix: How to Clean a Spark Arrestor Screen on a Small 2-Cycle Engine
This repair article will instruct you how to repair a dirty or damaged spark arrestor on your small engine.
Quick Fix: How to Replace the Spark Plug in a Small Engine
This article will help you replace the spark plug on a small engine which will help get your gas powered equipment up and running again.
How to Replace the Fuel Filters in Your Outdoor Power Equipment
This article will help you troubleshoot your fuel-line replacement repairs.
Discussion for the Black And Decker ASI300 Air Station Inflator
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Replace Circuit Fuse
How do I identify, purchase, and replace a circuit fuse for my B&D ASI300 120v/12v Air Station? I know I have to remove the six screws on the bottom of the Air Station, but then what? I can see the circuit board. Where do I purchase a new circuit fuse? Are there any tips to replacing the circuit fuse?
Reply: Replace Circuit Fuse
There are also 4 screws on the side holding the two side together. Remove them and gently working both sides apart shouldn't be difficult but be careful when putting back together. Can't lp on the fuse but I do know that you'll need to be decent with a soldering gun and fairly precision like as well. Hope this helps. Good luck.
Question: Black And Decker Air Station Inf...
Power cord to AC has stopped working. Cord to 12 volt Auto recepticle still works. Is there any possible repair to this condition?
Reply: Black And Decker Air Station Inf...
You can try replacing the cord with an appliance cord avail at any hardware store..but there may be some degree of difficulty of removing tamper proof screws[if applicable] or soldering to the control board..parts are not usually made available for these types as they just want you to replace..:D
Hope this helps?