Product Information
Description:
This is a genuine Briggs & Stratton replacement part. The belt cover is found on lawn mowers. This part is made of high-quality plastic, with an aluminum heat patch to protect it from the heat of the engine. It is used to cover and protect the drive belt. You will require a screwdriver when replacing this part. This item is sold individually. |
Compatibility
the 8 compatible machines
This part is compatible with the following machines:
Briggs and Stratton
Murray
7800885 (BTXPV226750HW) 22-In. 6.75GT Brute Steel Deck Self-Propelled Walk Behind Mower 2012
7800743 BTXP22700HW, 22-In. 7.0GT Brute High Wheel Steel Deck Self-Propelled Walk Behind Mower
7800583 (BTXP22675HW)(2010) 22-Inch 6.75gt Brute High Wheel Self-Propelled Walk Behind Mower
BTXP22700HW (7800743)(2011) 22-Inch 7.0gt Brute High Wheel Steel Deck Self-Propelled Walk Behind Mower
7800743 BTXP22700HW, 22-In. 7.0GT Brute High Wheel Steel Deck Self-Propelled Walk Behind Mower
7800583 (BTXP22675HW)(2010) 22-Inch 6.75gt Brute High Wheel Self-Propelled Walk Behind Mower
BTXP22700HW (7800743)(2011) 22-Inch 7.0gt Brute High Wheel Steel Deck Self-Propelled Walk Behind Mower
Products Compatibility
This item works with the following types of products:
- • Lawn Mower
Questions & Answers for Belt Cover
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
Tool Type:
Lawn Mower
Parts Used:
Repair Difficulty:
Medium
Time Spent Repairing:
30-60 minutes
Tools Used:
Screwdriver, Socket set, Wrench Set, Nutdriver, dremel with cut off wheel and emery cloth
Bearing on axle bad
Removed wheels first. Then remove E-clips from gears. Removed gears and pins. Removed dust covers. Then removed wheel adjusters. Bearings are located on adjusters inside and on shaft. One bearing came off easy. Other bearing was so bad had to cut inner and outer races with Dremel because the balls all fell out of bearing. Cleaned up shaft with emery cloth and reinstalled bearings both sides. Reassemble adjusters, dust covers, gears, wheels same as when you removed them. Make sure there is an E-clip on each side of axle shaft that rest against gears. These clips keep bears in the adjusters. Hope this helps.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information